Final project for EHM3131 – Communication 1 at Yıldız Technical University.
A MATLAB simulation of a Double-Sideband Suppressed-Carrier (DSB-SC) link: modulation, an AWGN channel at several noise levels, coherent demodulation, and time/frequency-domain analysis of how noise affects the recovered message.
- Modulation: I multiplied a 50 Hz message
m(t)by a 500 Hz carrierc(t)to gets(t) = m(t)·c(t). - Channel: I added white Gaussian noise (
awgn) at three SNRs: 15 dB (good), 10 dB (moderate), 3 dB (poor). - Coherent demodulation: I multiplied the received signal by the carrier, then low-pass filtered it
(5th-order Butterworth, 100 Hz cutoff, zero-phase
filtfilt) and corrected the amplitude. - Spectral analysis: I computed the FFT of the original and recovered signals.
- Plots: I made two figures comparing the original message with the three recovered versions, in the time and frequency domains.
| Parameter | Value |
|---|---|
Message frequency fm / amplitude Am |
50 Hz / 1 |
Carrier frequency fc / amplitude Ac |
500 Hz / 10 |
Sampling frequency fs |
10 kHz |
| Duration | 0.1 s |
| SNR values | 15, 10, 3 dB |
Requires MATLAB with the Communications Toolbox (awgn) and Signal Processing Toolbox (butter, filtfilt).
dsbChange fm, fc, the SNR values or the filter cutoff at the top of dsb.m to experiment.
At 15 dB the recovered message is close to the original. As SNR drops to 3 dB, the recovered waveform gets visibly noisier and the noise floor rises in the spectrum, while the 50 Hz message peak stays at the same frequency.