Minimal Timer0 driver and interrupt example for the Microchip PIC16F628A, written in C for mikroC PRO for PIC.
| Parameter | Value |
|---|---|
| Microcontroller | PIC16F628A |
| Original compiler | mikroC PRO for PIC v7.2.0 |
| System clock | 4 MHz |
| Peripheral | Timer0 (8-bit) |
| Timer clock | Internal instruction clock (FOSC/4) |
| Prescaler | 1:16 |
| Example output | RB0 |
The example toggles an LED connected to RB0 approximately every 500 ms. The full on/off cycle takes approximately 1 second.
timer0_init()configures Timer0 with the internal instruction clock and a 1:16 prescaler, clears its pending flag and enables the Timer0 interrupt. Global interrupts are enabled by the application.timer0_handle_interrupt()is called from the application'svoid interrupt()function. It clears the Timer0 flag and returns1every 122 overflows, or0otherwise.
Only one application interrupt routine should be defined. Additional interrupt sources can be handled in that same routine.
At a 4 MHz oscillator frequency, the instruction clock runs at 1 MHz. Timer0 overflows every 4.096 ms:
256 counts × 16 / 1,000,000 = 4.096 ms
122 overflows × 4.096 ms = 499.712 ms
Timer0 runs continuously, without software reloads. The resulting interval is approximately 499.7 ms, assuming an accurate 4 MHz oscillator. This is an educational example, not a precision timebase.
- Create a project in mikroC PRO for PIC targeting
PIC16F628A. - Set the project clock to 4 MHz and configure oscillator settings to match the physical circuit.
- Add
src/timer0.candexamples/main.cto the project, keepingsrc/timer0.hin place. - Build the project and program its generated HEX file into the device.
Connect an LED to RB0 through an appropriate current-limiting resistor.