Remote generation`?

[doc3d]

Is it possible to get ComfyInject to generate remotely? Right now, if I am on my main computer with ComfyUI running, it works as intended, but if I use ST remotely the image generation fails. I assume its because the ComfyUI is local and cant be reached when using ST remote, but is it possible to use the ComfyUI server to generate, that would open it up to generate from any device, or is my thinking flawed?

Any other way to generate the images remotely?

[EpharGy]

This can be setup, it's the way my setup works.

My setup is:
ST running on my NAS
Comfyui on my pc

accessing ST via browser on PC or mobile/tablet. I've shifted to using tailscale so everything is on the same 'network'

You'll need to setup your comfyui to allow remote connections (i think, was a while back i set this part up)

then i use tailscale, and use tailscale's magicdns for easy ip/dns management. I used to use OpenVPN

It sounds like your ST instance is setup fine if your ST runs fine remotely, so i think you only need to set it up so that you are able to connect to your comfyui instance also.

there are alternative ways via port forwarding and stuff like that if you don't want to use tailscale.

If you're only running on the same network (ie only at home), i think you only need to change the setting to make comfyui accessible from external sources and use your computers ip/port for comfyui (not locahost/127.0.0.1 the internal local ip)