diff --git a/board_configs/cp/nodisplay/esp32-p4-wifi6-dev-kit/board_peripherals.py b/board_configs/cp/nodisplay/esp32-p4-wifi6-dev-kit/board_peripherals.py
index 074fc8b..c92129e 100644
--- a/board_configs/cp/nodisplay/esp32-p4-wifi6-dev-kit/board_peripherals.py
+++ b/board_configs/cp/nodisplay/esp32-p4-wifi6-dev-kit/board_peripherals.py
@@ -10,6 +10,9 @@
 clocks MCLK at 256 times the sample rate, the tree the ES8311 driver
 programs, so any rate plays. The speaker header and the 3.5 mm jack carry
 the same DAC; headphones in the jack cut the speaker in hardware.
+
+``camera()`` is the OV5647 (or another MIPI-CSI sensor) on the CSI connector,
+through cameraif, when the firmware has it.
 """
 
 import board
@@ -22,7 +25,7 @@
 # any leftover display here leaves a headless app with no console to redraw.
 displayio.release_displays()
 
-PERIPHERALS = frozenset({"audio_out", "audio_in", "audio_power", "i2c", "sdcard", "boot_button"})
+PERIPHERALS = frozenset({"audio_out", "audio_in", "audio_power", "i2c", "sdcard", "camera", "boot_button"})
 
 _VOLUME = 100  # 0 dB: the loudest the ES8311 plays without clipping
 
@@ -139,6 +142,24 @@ def sdcard():
     )
 
 
+def camera(**kwargs):
+    """MIPI-CSI camera on the CSI connector (an OV5647 has run on it).
+
+    Any ``cameraif.Camera`` keyword passes straight through. The SCCB bus is
+    the board I2C: cameraif joins the ``board.I2C()`` bus rather than opening
+    a second master on the same pins, which would leave the codec and touch
+    controller timing out.
+    """
+    import cameraif
+
+    if not cameraif.available():
+        raise NotImplementedError("cameraif is not in this firmware, or it has no camera sensor driver")
+    kwargs.setdefault("sda", 7)
+    kwargs.setdefault("scl", 8)
+    kwargs.setdefault("i2c", i2c())
+    return cameraif.Camera(**kwargs)
+
+
 def boot_button():
     """The BOOT button (GPIO35, ``value`` False when pressed)."""
     import digitalio